Polycade Magnet Decal Installation & Care Guide

Magnets need gentle heat to become flexible enough to wrap around panel edges without creasing.

A standard blow dryer (preferred over heat guns because it won’t overheat the surface).

Initial Alignment

1. Place the magnet on the control panel.

2. Slide and reposition until the artwork is where you want it.

3. Do not bend or force edges yet — just focus on positioning.

Heating Process

1. Turn the blow dryer on medium.

2. Move it back and forth above and below the magnet.

3. Heat for about 2.5–3 minutes.

4. If you need to reposition during heating, that’s fine — just avoid touching hot spots directly.

Once the edge reaches about a 45° angle, begin flattening the front surface.

Hold the top area down while flattening the edge to keep the overlay secure.

If it becomes too hot, wait 10–15 seconds before continuing.

Tip: The full edge-wrapping process usually takes 10–15 minutes, but there’s no rush. Go at your own pace.

Removing Existing Magnet Decals:

1. Lift from a corner only.
Never pull from the middle — this can separate the artwork from the magnet backing.

2. Go slow and steady.
The magnets are heavy-duty, but rough handling can still cause tearing.

3. Small gaps are normal.
If you see slight spacing between the decal and panel, that’s perfectly fine.

Removing Magnets for Storage

1. Apply light heat to any 90 degree bends with a blow dryer before removal.

2. This helps the magnet flatten back out and prevents vinyl creasing.

3. Lift from the corners only, never the center.

Use a strap, band, or tie to keep layers from shifting.

The key rule: Keep magnets flat and stable.

If you encounter alignment problems, creasing, or damage concerns:

→ Reapply gentle heat and readjust.

→ Don’t force bends or corners.

→ Contact Polycade Customer Support promptly for assistance.

Take your time, apply heat gradually, and handle corners gently. The magnets are designed to be flexible and forgiving — careful installation and flat storage will keep your Polycade setup looking sharp for years!