Setup Instructions (cont'd)

RetroGlow Marquee (second version)

These are the continuation of the instructions here:
https://polycade.com/pages/info-marquee

These instructions relate to the second version of the RetroGlow marquee backlights, which uses two linked strips of LEDs and a red & black power cable (pictured below), as opposed to the old version which used a whole acrylic LED panel.

9. Locate the 12v port - depending on which mainboard version you have, it looks a little different (refer to the photos below). Most likely, you have a v2 mainboard, in which case the 12v port is the only RED one.

That's it, you're done!